Skip to content

← All terms

Reamer size

What size reamer do I need for a bore?

Start at about 1.5 times the outside diameter of what you are pulling. A 4.5 inch OD pipe gets a reamer near 6.75 inches. Use 1.25 times in clean, stable soil and go toward 2 times for a long pull, rock or clay that swells.

The pilot hole is small. The reamer opens it up on the way back, and the hole it cuts has to be bigger than the product, because the pipe needs room to move and the drilling fluid needs room to carry cuttings out. Cut it to the exact pipe size and the pull binds.

The rule of thumb

Multiply the product's outside diameter by a backream factor:

  • 1.25 times: easy, stable soil where you want to save fluid and spoil.
  • 1.5 times: the usual starting point.
  • 1.75 to 2 times: long shots, hard ground, or clay that swells and closes the hole.

The factor is a judgment call, not a code requirement. If a spec or the pipe maker names a hole size, that governs.

Worked example: one pipe

Pulling 4 inch IPS HDPE, which has a 4.5 inch outside diameter. At 1.5 times: 4.5 x 1.5 = 6.75 inches. Reamers come in set sizes, so you round up to the next one you own or can rent. At 1.25 times it would be 5.6 inches, and at 2 times it would be 9 inches.

Worked example: a bundle of conduits

Several equal conduits pulled together act like one bigger round pipe. The bundle diameter is a fixed multiple of one conduit's OD: 2 conduits is 2 times, 3 is about 2.15 times, 4 is about 2.41 times, and 7 is 3 times. Say you pull four 2 inch IPS conduits, 2.375 inches OD each:

  • Bundle: 2.375 x 2.4142 = about 5.73 inches.
  • Reamer at 1.5 times: 5.73 x 1.5 = about 8.6 inches.

That assumes the conduits lie in a tight cluster. Loose conduits take more room, so check how they are strapped before the pull. The reamer size calculator does this math for any count and backream factor.

What a bigger hole costs

A larger hole lowers pull friction, but it also uses more drilling fluid, makes more spoil to vac and haul, and takes longer to ream. The drilling fluid calculator shows the volume side of that trade. Pipe weight matters too for the pull itself; see what DR means on HDPE pipe.

Common questions

Can I ream the hole the same size as the pipe? Not safely. With no clearance the pipe binds and the fluid has nowhere to carry cuttings, which is how product gets stuck.

Does a bigger reamer always pull easier? Easier, but not free. You pay in fluid, spoil and reaming time, so go bigger only when the length or ground calls for it.

Do I ream in one pass? Often not on larger pipe. Crews step up in passes, and the final pass is the one sized with the factor above. Follow your driller's judgment and the rig's limits.

Boring crews keep the shot, fluid and footage record on the job so closeout is not a scramble. See TrackOver for drilling and boring if that sounds useful.

Related

More from the dirt world

TrackOver keeps the as-builts, markout tickets, hours, and job costs this page talks about. Start free, or see how it works.

Keep the job, the photos and the invoice in one place

TrackOver is job tracking for excavation, utility, paving, snow and lawn crews. Try everything free for 7 days.

  • No card to start
  • Cancel any time, no contract
  • Export your data whenever you want