Potholing / daylighting
What is potholing, and why do it before you bore or dig near a line?
Potholing, also called pothole excavation or daylighting, means carefully exposing a buried line, by hand tools or vacuum excavation, so you see where it really is and how deep. Marks show roughly where a line runs. Exposing it is how you confirm it before a bore or a bucket gets close.
A locate mark is an approximate horizontal position. Georgia 811 describes potholing as "the use of hand tools or vacuum excavation methods to expose buried utility lines" and recommends it to determine the tolerance zone. Some people call the same thing daylighting.
Why it matters for bores and trenches
A bore path or a trench that crosses a marked line is where a mark can be wrong by the most that matters, and you can't see the pipe from the surface. Opening a small hole at the crossing tells you the line's depth, its size, what it is made of, and whether it is where the paint says. OSHA's excavation rule 29 CFR 1926.651(b)(3) says that when excavation approaches the estimated location of underground installations, "the exact location of the installations shall be determined by safe and acceptable means."
How it is usually done
- Start with the ticket. Marks first, then expose. Follow your state's one-call law and the competent person on your site.
- Know your state's tolerance zone. In Georgia it is 18 inches either side of the outer edge of the line. Other states differ.
- Use hand tools or vacuum excavation inside the zone. Georgia 811 lists hand digging, potholing, soft digging and vacuum excavation among the ways to use reasonable care there, and says to avoid sharp tools that could damage a line.
- Expose at crossings. On a bore, pothole where the path crosses a line and at the entry and exit if lines are near. Your bore plan decides how many.
- If you damage a line, Georgia's guidance says to call 811 and the line's owner, and 911 if it carries a hazardous material. Check your own state's rule.
Record what you found
The hole is open for a short time, so get the record while it is. Put a tape or rod in the hole with the reading visible, and shoot the line with it. Then measure to something permanent: a foundation corner, a curb, a pole. Write the depth and the offset on the photo. On an as-built, those two numbers are the point of the whole exercise.
TrackOver's jobsite camera stamps each photo with date, time, job address and GPS when the phone has a fix, and files it to the job. As-built markup, where you draw arrows and write the depth and offset right on the photo, is on the Premium plan. See jobsite photos and what to shoot before backfill.
Sources, checked 2026-11-15: Georgia 811, georgia811.com/heavy-equipment-users; OSHA 29 CFR 1926.651, osha.gov.
Common questions
What is pothole excavation? Digging a small hole to expose a buried line so you can see its depth, size, material and exact position. It is done by hand tools or by vacuum excavation, and it is the same job people also call potholing or daylighting.
What is vacuum potholing? Potholing with a vacuum excavator instead of a shovel. A suction hose pulls the soil out of a small hole so the line is exposed without a blade or bucket touching it.
What is a vacuum truck for potholing? A truck with a suction system and a debris tank. The operator vacuums spoil out of the pothole into the tank, then the hole is backfilled once the line has been measured.
What are hydro vac potholes? Holes dug with a hydro vac, a vacuum excavator that also has a water lance. The water loosens the soil and the vacuum removes the slurry. Hydro vac is vacuum excavation with water added, so it suits ground that is hard to pull loose dry.
How does potholing work? Check the ticket and the marks first. Open a small hole on the marked line with hand tools or vacuum, stop when the line shows, measure its depth and its offset from something permanent, photograph it, then backfill. Those readings tell you how much room a bore or trench really has.
What is vacuum excavation for potholing and daylighting? Using suction to remove soil so a buried line is exposed without being struck. Georgia 811 lists vacuum excavation among the methods that expose buried utility lines. Daylighting is the same idea, bringing the line into view.