Skip to content

All help articles

Measure a site from the aerial map

Trace the trench, pipe or cleared area on the map and get the feet and square feet to bid, without walking the whole site with a tape. Then send the quantities to an estimate.

Open Site Takeoff

1. Find the site

In the left menu, click CRM, then the Site Takeoff tab. Type the address or town in the box and press Find site. The aerial map moves to the property.

2. Pick Line or Area

Choose Line (trench / pipe) for trench, pipe or conduit. Choose Area (clearing / paving) for clearing, restoration or paving. Type a label such as 8in sewer so you can tell the runs apart later.

3. Trace it on the map

Click each point along the run, or around the area. Press Undo point to take off the last point. Then finish the run or the area under the map. The shape shows on the map as you go.

4. Read the quantities

Each shape is listed with its feet or square feet. For trench you bid by the cubic yard, turn on Include cut/fill (CY) and the spoil goes on its own line, with a second line for area cut and fill when you traced an area. Leave it off if you bid the trench by the foot.

5. Send it to an estimate

Press Send to an estimate and pick the customer's lead from the list. Leads already turned into a job are not listed, and it shows the first 40, so type a name to search. If they are new, press New customer first. TrackOver starts a draft estimate with the quantities filled in, and you put your prices on each line.

Pro tip: The numbers come from the map, so check the trace against the site before you bid. Walk the ends where the run meets a fence, a driveway or a building.